Brake fluid DOT 4
Brake fluid DOT 4 260/165
BRKFLUD-(DOT 4)-500ML
Register now and access more than 125,000 products
Meets and exceeds the current international specifications of U.S. FMVSS No. 16 DOT 4, SAE J1703 and ISO 4925 (Class 3)
Suitable for use in passenger cars, commercial vehicles and motorcycles with hydraulic brake systems and clutch systems; recommended where a non-petroleum-based medium has to be used. Not suitable for vehicles with mineral oil-based systems (e.g. certain Citroen models). If in doubt, consult the vehicle manual.
Min. dry boiling point 260°C. Min. wet boiling point 165°C
Keep brake fluid clean and dry. Contamination by dirt, water, petroleum products or other materials can lead to brake failure or costly repairs.
Store brake fluid only in its original container. Keep the container clean and tightly closed to prevent the accumulation of water. Do not refill the container and do not use it to store any other liquids. Dispose of used brake fluid responsibly (EU waste code 160113). Brake fluid damages paintwork – if spilled, wash off immediately using plenty of water. When using Würth 5-litre brake fluids, pierce the centre of the foil seal and screw on the tap. Do not attempt to remove the foil seal, as this will prevent the tap from being properly sealed.
Datasheets(X)
Vehicles
Brake fluid must be changed every 2 years. Follow the vehicle manufacturer's recommendations when adding brake fluid.
Contents | 500 ml |
Colour | Pale Amber |
Chemical basis | Butoxyethanol |
Shelf life from production | 36 Month |
Min. wet boiling point | 165 °C |
Min. dry boiling point | 260 °C |
Density | 1.052 g/ml |
Density conditions | at 20°C |
pH value | 7-11 |
Last viewed
Covering plug Type 9
Adhesive tape 4965
Cone grease nipple Angled shape 90° DIN 71412 shape C, zinc-plated steel
CO2 leakage tester set 2 pieces in system case 4.4.1.
Twist drill bit HSCo DIN 338 type RN oxide
HHS® Clean adhesive lubricant pre-cleaner
Crimp cable lug, fork shape Polyamide insulated
Diamond cutting disc Turbo
Slotted cheese head DIN 84, steel 4.8, zinc-plated, blue passivated (A2K)
Concrete screw with hexagon head W-BS/S